Products

About Us

Knowledge Center

Accessories

Terms of Use

Featured Products

Site Map

Videos

Contact Us

Motorized Z-axis Table

Home >  Assorted Motorized Multi-axis Stages >  Motorized Z-axis Linear Positioning Stages


This motorized positioning table is made of aluminum alloy with an elegant black anodized surface.

It provides 150 mm of travel at a Maximum Speed with Stepper Motor of 40 mm per second. The drive mechanism is lead screw.

The bench size is 150 X 150 mm and has a body weight of 4.5 Kg.

The maximum load of this stage table is 40 Kg.

The resolution of 2 microns is achieved with a 10 micro-steps per step stepper motor driver. This linear stage is
also available with a Three Phase Brushless Servo Motor and optical encoder.

The knob mounted on the motor allows for manual adjustment. This knob may be replaced with an optical encoder for precision position verification.

This stage requires a Motion Controller that can be ordered as a complete plug-and-play system with RS-232, USB, joystick, trackball, and keypad control.

 

Specifications
Type

Z150-150H

Structure Description

Travel

150 mm

Stage Size 150×150 mm
Lead Screw Pitch  4 mm per turn
Travel Guide

High Precision Linear Slide Guide

Two-Phase Stepper Motor (1.8°)
Typical Phase Resistance 3.8 Ohms,  Bi-directional
Typical Phase Current 1 Amp
DB-9 Male Connector
Pin Assignment and Description

1

+5 VDC

2

CW Limit Switch, Open Collector, Normally Open, Needs Pull up Resistor

3

CCW Limit Switch, Open Collector, Normally Open, Needs Pull up Resistor

4

Common

5

Not Connected

6 Stepper Motor Phase A+
7 Stepper Motor Phase A-
8 Stepper Motor Phase B+
9 Stepper Motor Phase B-

 

Body Material Aluminum Alloy
Surface Treatment Black Anodized
Load Capacity 10 kg
Weight 4.5 kg

Typical Accuracy

Resolution Control Electronics Dependent, 2 microns with 10 Micro-steps per Step Motor Driver in use
1 micron with 10 Micro-steps per Step Motor Driver in use
Maximum Speed with Stepper Motor 25 mm/sec
Maximum Speed with Servo Motor  
Positioning Accuracy 10 microns

Accessories Description

Optical Encoder
Three Phase Brushless Servo Motor and Optical Encoder (-02 Version)


Stepper Motor Driven Mechanical Drawing


 Ordering Information

Part No. Description Amount
Z150-150H-01 Stepper Motor Driven Linear Single-axis Stage, Travel  : 150 mm Click to Get a Quote
Z150-150H-02 Three Phase Brushless Servo Motor with Quadrature Incremental Optical Encoder Driven Linear Single-axis Stage, Travel  : 150 mm Click to Get a Quote

OES line of Motion Controllers Motion Controllers
Sharing link:


 

Home | Products | Accessories | Knowledge Center | About Us | Terms of Use |Testimonials | Featured Products |Site Map | Videos | Contact Us