the motion control company
(888) 777-1826
+1 (818) 222-9200

Home About Us Site Map Videos Distributors Contact Us
Products
Motion Controllers
Solenoid Control Electronics
Linear/ Rotary Actuators and Stages
Motors
Motor Drivers
Power Supplies
Accessories
Two-axis Joystick
Three-axis Joystick
Trackball
Operator Interface Terminal
Switch Selector
Knowledge Center
Motion Control Components
About Us
Site Map
Videos

 

Load On-Off Power Cycling Module

Data Sheet
Wiring Diagram

Similar Solenoid Controller and Driver Products

Pick and Hold Module 
Proportional (PWM) Module
Closed Loop Solenoid Position Control Module
Pick and Drop Module
Load On-Off Power Cycling Module
Dual Proportional Valve Controller
Solenoid Control System
Related Products
USB Control Card
Power Supplies

 

Features

  • Low Cost

  • Small Size

  • Low Weight

  • High Efficiency

  • Microcomputer Based

  • Very High Reliability

  • Pulse Width Modulated (PWM)

  • Single Supply, from +9 VDC to +50 VDC

  • High Supply Voltage, +50 VDC

  • High Output Current 15 Amps Peak, 4 Amps RMS
  • RoHS Compliant 

  • QUANTITIES AVAILABLE IN STOCK
 
Typical Applications
  • Solenoids

  • Valves

  • Relays

  • Actuators

  • Voice Coil Actuators

  • DC Motors

  • Hydraulics

  • Electromagnets

  • LEDs

General Specifications

  • Supply Voltage, +9 to +50 VDC

  • Peak Current, 15 Amp

  • Average Current, 4 Amp
 

The Load On-Off Cycling Module is designed to enable the user to cycle the voltage across a solenoid or other devices. The applied peak voltage, duty cycle and the frequency are adjusted using three onboard potentiometers.

There are three onboard adjustment potentiometers.

The first potentiometer adjusts the frequency of actuation. The range of the frequency is from 0.14 through 30 cycles per second. The second potentiometer adjusts the output voltage. The duty cycle of the actuation (ratio of on time to the length of one full cycle) may also be adjusted using the third potentiometer.

It is possible to run multiple modules using the designated master board signal generator.
This product is RoHS compliant.

Performance Specifications

Parameter

Min

Typical

Max

Units

Supply Voltage

9

 

50*

VDC

Peak Current    

15**

Amp

Average Current  

 

4

Amp

Cycling Frequency

0.14

 

20

Hz

Operating Temperature 0   50 Deg C

*    80 VDC version is also available.
**  50 Amp version is also available.

Timing Diagram

Mechanical Specifications

Mounting Pattern Four 6-32 Screws, 0.15" Diameter (3.8 mm)
Dimensions 3.00” W, 3.00” D, 0.85” H (76.2 mm, 76.2 mm, 21.5 mm)

Ordering Information
 
Part No. Description Amount
LOC-01 Single-device Load On-Off Cycling Module, +50 VDC Version $129.18
LOC-01-HV Single-device Load On-Off Cycling Module, +80 VDC Version Inquire
       

Home | Products | Accessories | Knowledge Center | About Us | Terms of Use |Testimonials |  Site Map |  Videos | Distributors | Contact Us

Optimal Engineering Systems, Inc.

Los Angeles, California, USA

 Toll Free Number (888) 777-1826 in USA

+1 (818) 222-9200

  sales@oesincorp.com

Contact Us

Copyright ©  1998 - 2011 Optimal Engineering Systems, Inc., All Rights Reserved